Stillwater Lift Bridge to close Tuesday for electrical work, MnDOT says

The historic Stillwater Lift Bridge will close from 7 a.m. to 3 p.m. Tuesday so an electrical cable used to operate the lift mechanism can be replaced, according to the Minnesota Department of Transportation.

MnDOT said Friday that all pedestrian and bicycle traffic will be suspended during that time. The lift span of the bridge will remain down so smaller boats on the St. Croix River will still be able to pass underneath. If there is inclement weather, the repairs will be postponed until Wednesday during the same hours.

On Thursday, the bridge got stuck in the down position for nearly six hours before MnDOT restored operations. It wasn’t clear whether the planned cable replacement was related to Thursday’s problem.

The historic bridge, which was closed to car traffic when the new St. Croix River bridge was built, is a key part of the Loop Trail, a 4.7-mile interstate trail between Houlton, Wis., and Stillwater that also crosses the new bridge south of Stillwater.

The old bridge lifts regularly in the summer to accommodate marine traffic.

Related Articles

News |


As part of I-94 project, ramp closures set to begin this week along I-494 and Tamarack Road

News |


Overnight closure of I-694 in Oakdale on Friday night was rescheduled due to weather

News |


State Patrol calls bystanders ‘heroic’ for pulling man from burning car in St. Paul

News |


2 women killed when UTV collides with pickup truck in Benton County, sheriff says

News |


Lane reductions start this week as I-94 reconstruction enters homestretch in east metro

Leave a Reply

Your email address will not be published.

Previous post Dear Abby: Partner’s a financial hot mess & it’s costing me
Next post Rookie Alissa Pili breaks out in Lynx’s 95-71 rout of Phoenix